Canon imageFORMULA DR-X10C User Manual page 82

Frame Detection Error Mode Setting
If set to ON, an error message is displayed when the correct paper
size of the image cannot be detected.
If detection fails, the sensor may have failed.
IMPORTANT
• When the error message is displayed, clean both the sensor glass
and the reading glass. (See "Cleaning the Glass" on p. 89.)
• If an image cannot be scanned normally after the glass has been
cleaned, the glass may have been scratched. In such a case,
contact the sales dealer or request a servicing.
Tray Position Setting
The document tray should be set to match the number of document
sheets to be loaded (100, 300, or 500 sheets).
Document Feed Tray" on p. 39.)
0: Up to 500 sheets (default setting)
1: Up to 300 sheets
2: Up to 100 sheets
Separation Torque Setting
This setting adjusts the torque (force of rotation) of the retard roller
when the scanner's capability of separating document pages has
degraded due to roller wear, or when feeding materials that do not
feed easily, such as thin paper.
The default setting is [3]. To increase torque when scanning thick
paper or documents that do not transport easily, set Torque Control to
[4] or [5].
To reduce the torque for scanning thin paper, set Torque Control to [1]
or [2].
Thin Paper Feed Setting
Appears when the optional Thin Paper Kit for DR-X10C is installed. If
set to [ON], document sheets that are thinner than normal can be
(See "Preparing the
used. To fully utilize the functions of the Thin Paper Kit for DR-X10C,
set this to [ON].
p. 129.)
For details about the Thin Paper Kit for DR-X10C, contact your local
authorized Canon dealer or service representative.
82
(See "Thin Paper Kit for DR-X10C Specifications" on