Canon imageFORMULA DR-X10C User Manual page 80

Staple Detection Level Setting
Sets the staple detection sensitivity level.
[1] is the default setting, [2] provides higher sensitivity, and [0]
provides lower sensitivity.
Long Document Mode Setting
You can enable this mode to detect and scan document pages up to
118.1" (3 m) long when the Auto Detection page size setting is
selected. (See "Long Document Mode Setting" on p. 36.)
ON2: Automatically detects page sizes when scanning documents up
to 118.11" (3 m) long.
ON1: Automatically detects page sizes when scanning documents up
to 39.37" (1 m) long.
OFF: Automatically detects page sizes when scanning documents up
to 17.01" (432 mm) long.
Hint
Feeding a document longer the maximum detectable page size for
Auto Detection causes a paper jam indication, and transport stops.
Continuous Manual Feeding Mode
Setting
This mode disables automatic feeding by the pickup roller, so that the
loaded document stack must be fed by hand one sheet at a time by
the operator. (See "Continuous Manual Feeding Mode" on p. 48.)
ON: The pickup roller is disabled.
OFF: Documents are fed by the pickup roller.
Stand-by Mode Setting
Selects the amount of time (240, 60 or 10 minutes) from when the
scanner is last used to when the Stand-by mode is activated.
Auto Power OFF Mode Setting
Sets the Auto Power OFF function. When this setting is set to [ON],
the scanner will turn OFF automatically if no operations are performed
for 4 hours.
ON: Enables the Auto Power OFF function.
OFF: Disables the Auto Power OFF function.
80