Basic Operation; Turning The Power On And Off; About The Power Switch - Canon imageFORMULA DR-X10C User Manual

Basic Operation

Turning the Power ON and OFF

Use the power switch to turn the DR-X10C scanner ON and OFF, or if you are using a USB connection, you can set the USB-linked power switch.
CAUTION
• After turning the scanner OFF, wait at least ten seconds before
turning it back ON.
• If the scanner is connected via SCSI cable, always turn the scanner
ON before turning the computer ON. If you turn the computer ON
before the scanner, it may not recognize the scanner properly.

About the Power Switch

When the power switch (located at the lower left side of the front of the
scanner) is turned ON, the Document Feed Tray opens automatically.
(See p. 39.)
Power Switch
USB-Linked Switch Setting (with USB
connection only)
To set to have the computer's power switch turn the scanner ON and
OFF as well, you can enable the Auto USB Power Off function.
You can change the "Auto USB Power Off" setting using the User
Mode.
1
Press the Menu key on the control panel.
The User Mode is activated.
33
Menu Key