Infra - Lightware HDMI-TPS-TX226 User Manual

   
5.SoftwareControl-LightwareDeviceController
SalvoHttp Status Page (Receiving HTTP Message)
DIFFERENCE:
ThisfeatureisavailableonlyforSW4-TPS-TX240-PlusfromFWpackagev1.3.0b6.

ATTENTION! ThisfeaturemeanssendingHTTPmessagesfromanexternaldevicetotheLightwaredevice.
Encrypted transmission (HTTPS) is not supported.
Inthiscase,abatchofcommandscanbesentoverHTTPtotheLightwaredeviceforprocessing.Postthe
commandstothe<IP_address>/protocol.lw3addressandthecommandsareprocessedimmediatelyand
sequentially. #http
ControlcommandscanbesenttotheLightwaredevice,butitisnotsuitableforqueryingaparameter/status 
sincetheLW3responsesarenotsentbacktothesender.

ATTENTION! If the CleartextLogin(LoginSettings)isenabledinthedevice,theloginhastobethefirst
command.Nocommandswillbeprocessedwithoutasuccessfullogin.SeethesyntaxintheLoginthe
Device section.
SalvoHttp tab in the Control/Ethernet menu
HDMI-TPS-TX200series–User'sManual
5.9.4. Infra

ATTENTION!
anIRemitterunittotheIROUTandanIRdetectorunittotheIRINconnectors.
Infrared (IR) receiver and transmitter options can be found on this tab. There are three submenus are
availableunderit:IR codes, Ports, and Clear all IR codes.
IR Codes
TheusercansetthenameoftheIRcode,thefingerprint(hash),andtherepeattimeoutinms,actionscan
beorderedtoeachIRcodeaswell.
Appliedfirmwarepackage:v1.3.2b3 | LDCsoftware:v2.5.7b2
Thedevicehasnobuilt-inInfraredreceiverandtransmitter.Forthecompleteusageattach
#infra #infrared
IR codes window in Control menu
51