FIC VT-502 Manual page 58

Onboard UART2 Mode
Allows you to select the IR modes if the serial port 2 is used as an IR port.
Set at Standard, if you use COM2 as the serial port as the serial port, instead
as an IR port.
The options are: HPSIR, ASKIR, Standard (Default).
IR Duplex Mode
This feature allows you to select the infrared data transaction way.
The options are: Half (Default), Full.
Use IR Pins
Allows you to select the RX and TX pins of IR modules.
The options are: IR-RX2TX2 (Default), IR-RX TX.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: 378/IRQ7 (Default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Allows you to connect with an advanced printer.
The options are: Nomral (Default), Extended, EPP Mode, ECP Mode,
ECP+EPP Mode.
ECP Mode Use DMA
If your select ECP mode to be the parallel port mode, this feature allows you
to select Direct Memory Access (DMA) channel.
The options are: 3 (Default), 1.
Parallel Port EPP Type
If you select EPP/SPP mode to be the parallel port mode, this feature allows
you to select the EPP type version.
The options are: EPP1.9, EPP1.7 (Default).
Award BIOS Setup
53