FIC VT-502 Manual page 46

Boot Sequence (LS120/ZIP100)
Allows the system BIOS to first try to boot the operating system from the
selected disk drive.
The options are: A, C (Default); C, A; C, CDROM, A; CDROM, C, A; C
Only; LS/ZIP, C.
Swap Floppy Drive
Allows you to switch the order in which the operating system accesses the
floppy drives during boot up.
The options are: Enabled, Disabled (Default).
Boot Up Floppy Seek
When enabled, assigns the BIOS to perform floppy diskette drive tests by
issuing the time-consuming seek commands.
The options are: Enabled (Default), Disabled.
Boot Up Numlock Status
When set to On, allows the BIOS to automatically enable the Num Lock
Function when the system boots up.
The options are: On (Default), Off.
Boot Up System Speed
Allows you to adjust the system speed when the system boots up.
The options are: High (Default), Low.
Gate A20 Option
When set at Fast, allows a faster access response under Protected mode.
The options are: Fast (Default), Normal.
Typematic Rate Setting
The term typematic means that when a keyboard key is held down, the
character is repeatedly entered until the key is released. When this item is
enabled, you may change the typematic repeat rate.
The options are: Disabled (Default), Enabled.
Typematic Rate (Chars/Sec)
Sets the rate of a character repeat when the key is held down.
The options are: 6 (Default), 8, 10, 12, 15, 20, 24, 30.
Award BIOS Setup
41