FIC VT-502 Manual page 33

3. Holding the edge of the peripheral card, carefully align the edge
connector
with the expansion slot. (See figure below.)
4. Push the card firmly into the slot. Push down on one end of the
expansion card, then the other. Use this "rocking" motion until the
add-in
card is firmly seated inside the slot.
5. Secure the board with the mounting screw removed in Step 2.
Make sure that the card has been placed evenly and completely into
the
expansion slot.
The photo below shows an add-on card that was installed in a system.
Installation Procedures
29