Installation Procedures
1). Set System Jumpers
Jumpers
Jumpers are used to select the operation modes for your system. Some
jumpers on the board have three metal pins with each pin representing a
different function. To set a jumper, a black cap containing metal contacts is
placed over the jumper pin/s according to the required configuration. A
jumper is said to be shorted when the black cap has been placed on one or
two of its pins. The types of jumpers used in this manual are shown below:
NOTE : Users are not encouraged to change the jumper settings not listed in
this manual. Changing the jumper settings improperly may adversely affect
system performance.
11