Engine Stopper - BRP Lynx Commander 800R E-TEC 2018 Operator's Manual

mmo2008-008-007_a
USED SPARK PLUG
1. Tighten 1/10 of a turn
Using a Torque Wrench
Tighten spark plugs to the specified
torque.
TIGHTENING TORQUE
Spark plug

Engine Stopper

Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove the drive belt guard, re-
CONTROLS, INSTRUMENTS
fer to
AND STANDARD EQUIPMENT
3. Loosen the three screws retaining
the engine stopper to the engine
support just enough to allow a verti-
cal play (1/2 to one turn).
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
28 N•m (21 lbf•ft)
.
_______________
MAINTENANCE PROCEDURES
4. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
mmo2010-009-001_a
1. Opening
2. Feeler gauge
5. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
6. Tighten screws to the specified
torque, following the illustrated se-
quence. Take care not to pinch the
feeler gauge.
81