Rear Rack; 12-Volt Power Outlet (Standard Type); Hitch - BRP Lynx Commander 800R E-TEC 2018 Operator's Manual

CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT
fmo2012-003-004
TYPICAL - BATTERY LOCATION

17) Rear Rack

The rear rack can accommodate per-
sonal articles (luggage), a fuel caddy or
the storage box.
WARNING
All objects in rear rack must be
properly latched. Do not carry
any breakable objects. Excessive
weight in rack may reduce steering
ability.
WARNING
Always readjust suspension ac-
cording to the load. The capacity
of this rack is limited, the MAXI-
MUM cargo load is 30 kg (66 lb).
Ride at very low speed when
loaded. Avoid speed over bumps.
18) 12-Volt Power Outlet
(Standard Type)
For NATO type 12-Volt outlets location,
SPECIAL EQUIPMENT
refer to
The standard type 12-volt power outlet
is located near the steering column.
A 12-volt electric appliance may be
connected to that socket.
If you need continuous current contact
an authorized Lynx dealer.
______________
46

19) Hitch

Use the hitch in conjunction with a tow
bar to tow an accessory.
When attaching any accessory, always
refer to the manufacturer's recom-
mendations.
NOTE: Refer to decal on vehicle for
towing weight capacities.
Never tow an accessory with a
rope. Always use a rigid tow bar.
Using a rope would result in a col-
lision between the object and the
snowmobile and possibly in a tip
over in case of a rapid deceleration
or on a downward slope.
J-Type Hitch
Attaching an Equipment
mmo2011-007-012_a
1. Hairpin clip
2. Safety tab
1. Remove the hairpin clip.
2. Align accessory attachment hole
.
with the hitch hook.
3. Push the accessory attachment
passed the safety tab.
4. Secure safety tab using the hairpin
clip.
Detaching an Equipment
1. Remove the hairpin clip.
2. Push safety tab forward to free ac-
cessory attachment from the hitch.
WARNING