BRP Lynx Commander 800R E-TEC 2018 Operator's Manual page 91

MAINTENANCE PROCEDURES
mmr2009-133-003_b
DEFLECTION SETTING
1. Bottom O-ring set to specification
6. Place upper O-ring to 0 kgf (0 lbf).
7. Position the tensiometer on track,
halfway between front and rear idler
wheels.
8. Push the tensiometer downwards
until bottom O-ring (deflection) be
aligned with the bottom of slider
shoe.
mmr2009-133-001_a
mmr2009-133-002_a
TYPICAL
1. Deflection O-ring aligned with slider shoe
9. Read load recorded by the upper
O-ring on the tensiometer.
______________
88
mmr2009-133-003_a
LOAD READING
1. Upper O-ring
10. Load reading must be as per the
following table.
TRACK ADJUSTMENT
SPECIFICATION
TRACK
DEFLECTION
TRACK LOAD
READING
11. If load reading is not in accordance
with the specification, adjust track
tension. Refer to
SION ADJUSTMENT
NOTICE
Too much tension will
result in power loss and excessive
stress on suspension components.
Track Tension Adjustment
1. Remove the tether cord cap from
engine cut-off switch.
2. Remove rear wheel caps (if so
equipped).
fmr2008-048-007_a
TYPICAL
1. RH rear idler wheel cap
3. Loosen the rear idler wheel retain-
ing screws.
40 mm to 50 mm
(1.5 in to 2 in)
7.3 kgf (16 lbf)
TRACK TEN-
.