Storage Box; Shovel / Saw; Spare Drive Belt - BRP Lynx Commander 800R E-TEC 2018 Operator's Manual

CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT
NOTE: Do not sit or lean on seat when
fuel tank cap is not properly installed.

30) Storage Box

Storage Box Opening/Closing
To open storage box lid, release both
rubber ties, then lift lid up.
619900929-007_a
1. Rubber tie
To close, push lid down in order to in-
sert the lid pins into the box grommets.
Attach the rubber ties.
For details on the storage box content,
SPECIAL EQUIPMENT
refer to
Storage Box Removal/Installation
To remove storage box from vehicle,
open lid and remove the four screws
retaining storage box to the rear rack.
Keep the screws for installation.
mmo2010-002-013_a
TYPICAL - INSIDE THE STORAGE BOX
1. Retaining screw
______________
52
To install storage box, make sure that
the tunnel surface is clean. Put stor-
age box within the rear rack rails.
Attach
Tighten
(89 lbf•in ± 9 lbf•in).

31) Shovel / Saw

The shovel (with enclosed saw) is lo-
cated on RH side of vehicle.

32) Spare Drive Belt

A spare drive belt is stored in a holder
located on the drive belt guard.
To install a spare drive belt. position it
into the drive belt guard slot.
.
520001663-007_b
TYPICAL
1. Drive belt guard
2. Slot
Secure in place by sliding it behind the
tabs.
520001663-007_c
TYPICAL
using the four
to 10 N•m ± 1 N•m
screws.