BRP Lynx Commander 800R E-TEC 2018 Operator's Manual page 96

619900929-020_a
Step 1: Disengage the top
Step 2: Disengage the bottom
3. By the opening, disconnect burnt
bulb connector.
4. Remove the rubber boot.
mmo2007-009-022_a
1. Rubber boots
5. Press and pull both sides of the re-
taining clip at the same time to re-
lease it from bulb support.
mmo2007-009-063_a
Step 1: Push both sides
Step 2: Pull to release
1. Retaining clip
6. Pull bulb and replace. Properly rein-
stall parts.
mmo2007-009-064_a
PULL BULB AND REPLACE
7. Verify headlights operation.
Headlights Beam Aiming
Remove multifunction gauge, refer to
HEADLIGHTS BULB REPLACEMENT
Turn knob to adjust beam height.
mmo2007-009-023_a
TYPICAL
1. Knobs
_______________
MAINTENANCE PROCEDURES
.
93