BRP Lynx Commander 800R E-TEC 2018 Operator's Manual page 92

fmr2008-048-008_a
TYPICAL
1. RH rear idler wheel screws
4. Tighten or loosen both adjustment
screws to increase or decrease
track tension.
fmr2008-048-009_a
TYPICAL
1. RH adjustment screw
5. If correct tension is unattainable,
contact an authorized Lynx dealer.
6. Retighten retaining screws.
TIGHTENING TORQUE
Idler wheel
screws (35 lbf•ft ± 4 lbf•ft)
7. Check track alignment as described
below.
48 N•m ± 6 N•m
_______________
MAINTENANCE PROCEDURES
Track Alignment
WARNING
Before checking track alignment,
ensure that the track is free of all
particles which could be thrown
out while track is rotating. Keep
hands, tools, feet and clothing
clear of track. Always lift the snow-
mobile on a wide-base stand with
a rear deflector panel. Ensure no
one is standing in close proximity
to the snowmobile, especially at
the rear of the track. Never rotate
track at high speed.
Centrifugal force could cause de-
bris, damaged or loose studs,
pieces of torn track, or an en-
tire severed track to be violently
thrown backwards out of the tun-
nel with tremendous force.
Start the engine and accelerate slightly
so that track barely turns. This must be
done in a short period of time (about 5
seconds).
Check that the track is well centered;
equal distance on both sides between
edges of track guides and slider shoes.
A01F05A
1. Guides
2. Slider shoes
3. Equal distance
If off center, perform alignment as fol-
lows:
1
2
3
89