11. CLI Commands
11.4.5 Displaying Port-Switching Alerts
Use this command to display an alert message in the command line interface whenever a port is switched via the DVOE Manager,
the B162 device push buttons or the IR remote control. To enable or disable this function, type the command in this format:
echo + on | off + \R\N
Control
on
off
\r\n
11.4.6 Looking Up System Settings
You can look up the following system settings using the list command:
• Video Wall IDs
• Device ID, MAC address, IP address, firmware version and device name of B162 transmitters and receivers
To look up system settings, type the command in this format: list + rx | tx | device | videowall + \r\n
Control
rx
tx
device
videowall
\r\n
Description
Sends an alert in the command prompt window to inform port switching
configuration. For example, when the user assigns the B162-001-POE with
the device ID of 2 to the B162-100-POE with the device ID of 3, the system
sends this message in the command prompt window: sw o2 i3 on
Disables the alert for port switching.
Ends the command.
Description
Lists the system information of all B162-100-POE receivers in the environment,
including the device IDs, MAC addresses, IP addresses, firmware versions and
device names.
Lists the system information of all B162-001-POE transmitters in the
environment, including the device IDs, MAC addresses, IP addresses, firmware
versions and device names.
Lists the system information of all B162 transmitters and receivers in the
environment, including the device IDs, MAC addresses, IP addresses, firmware
versions and device names.
Lists the video wall settings.
Ends the command.
46