Panel Controls - Tripp Lite B162-100-POE Owner's Manual

8. Panel Operation

8.3 Panel Controls

1
ID NUM BER
T
x
R
x
B162-100-POE
4K HDMI Over IP Extender with POE
Receiver
1. Tx/Rx LEDs – Indicate whether the displayed ID number is for the transmitter or receiver.
2. ID Number:
o Transmitter: Identifies its ID number.
o Receiver:
- Identifies its ID number or the transmitter's ID number when the panel control is switched to Tx.
- If the ID number exceeds 3 digits, letter A, b, c, d, E and F are used to replace the first 2 digits:
• A= 10, A00 ~ A99 to display ID number 1000 ~ 1099
• B= 11, b00 ~ b99 to display ID number 1100 ~ 1199
• C= 12, c00 ~ c99 to display ID number 1200 ~ 1299
• D= 13, d00 ~ d99 to display ID number 1300 ~ 1399
• E= 14, E00 ~ E99 to display ID number 1400 ~ 1499
• F= 15, F00 ~ F99 to display ID number 1500 ~ 1599
o ID Number blinks to indicate it is being used by another B162 device.
3. Up (+)/Down (-) Buttons:
a. Assign ID numbers on the devices.
b. Assign the source video (transmitter) for the receiver.
4. Tx/Rx Switch Button – Press to switch control between a receiver and its corresponding transmitter.
Notes:
• The B162 unit automatically locks its panel when it idles for 1 minute. To unlock, press and hold the Down button
for 3 seconds.
• Tx/Rx LEDs and Tx/Rx Switch button are available only on B162-100-POE receivers.
2 3 4
LAN
Tx / Rx
AUDIO IR RS-232
IN
Tx GND Rx
USB
B162-001-POE
4K HDMI Over IP Extender with POE
Transmitter
15
2 3
ID NUMBER
LINK POW ER