Tripp Lite B162-100-POE Owner's Manual page 13

7. Hardware Setup
Notes:
• The IR, RS-232 and USB signal transmissions are disabled by default. To enable them, go to System
Settings>Receiver>IR/RS232 or USB in DVOE Manager and select the signal source.
• Each transmitter can be controlled by 4 USB touchscreens connected to receivers.
• To receive HDMI audio on the transmitter, make sure to configure the following in DVOE Manager:
o Go to System Settings>Transmitter>Audio In, and change the setting to HDMI.
o To receive 5.1 or 7.1 surround sound on the receiver:
 - Go to System Settings>Transmitter, access the transmitter's configuration window, and set EDID to Manual.
 - From DVOE Manager's preview area, click the "three dots" (...) icon,
and select EDID to allow transmission of the receiver's EDID to the transmitter.
13