Hardware Setup; Components - Tripp Lite B162-100-POE Owner's Manual

7. Hardware Setup

7.1 Components

Before proceeding to hardware setup:
•Review the safety information regarding the placement of this device in Important Safety Instructions.
•Do not power on the device until all necessary hardware is connected.
B162-001-POE Front View
1
HDMI Input – Connects an HDMI cable to the source device.
2
Audio Input – Connects an audio cable to the source device's analog output.
Note: Does not support microphones.
3
Bi-Directional IR Port – Connects an IR receiver/transmitter to allow configuration using a remote control.
4
RS-232 Serial Port – Connects to a computer for serial control.
5
USB-B Port – Connects to the source device.
B162-001-POE Rear View
1
LAN Port with PoE – Connects a Gigabit Ethernet cable to the LAN.
2 DC Power Jack – Connects the DC Power Adapter to provide power to the transmitter.
LAN
1 2 3 4
IR
AUDIO
IN
1
LAN
IR
AUDIO
IN
8
5
RS-232 USB
Tx GND Rx
2
USB
RS-232
Tx GND Rx
B162-001-POE
4K HDMI Over IP Extend
Transmitter
B162-001-POE
4K HDMI Over IP Extend
Transmitter