Tripp Lite B162-100-POE Owner's Manual page 10

7. Hardware Setup
B162-100-POE Rear View
1
LAN 1 Port with PoE – Connects a Gigabit Ethernet cable to the LAN.
2
LAN 2 Port (no PoE) – Connects to another B162-100-POE with an Ethernet cable in a daisy-chain setup.
3
DC Power Jack – Connects the DC Power Adapter to provide power to the receiver.
B162-100-POE Top View
IR AUDIO
OUT
1
Tx/Rx LEDs – Light to indicate whether the displayed ID number is for the transmitter or receiver.
2
ID Display Panel – Identifies the transmitter's or the receiver's ID number.
3
Prev (+)/Next (-) Buttons – Assigns ID numbers on B162 devices,
and assigns the source video (transmitter) for the receiver.
4
Tx/Rx Switch Button – Press to switch control between the receiver and its corresponding transmitter.
5
HDMI Out LED – Lights orange to indicate a stable video output.
6
Link LED – Lights orange to indicate the LAN Port 1 is connected to an Ethernet switch.
7
Power LED – Lights green to indicate the unit is receiving power.
RS-232
Tx GND Rx
USB
1 2
LAN
1 2
1 2
ID NUM BER
T
x
R
x
B162-100-POE
4K HDMI Over IP Extender with POE
Receiver
IR AUDIO
OUT
3
3 4
Tx / Rx
5 6 7
10
B162-100-POE
4K HDMI Over IP
Receiver