• Further expand the range and number of monitors by adding B140-110 remote repeater units • Add up to three repeaters on each of the B140-002-DD channels, for a total of 4 displays per channel (An active receiver should be the last unit in a channel) • A 1920 x 1080 @ 60Hz signal can be extended up to 125 ft.
Page 3
* When converting DVI to HDMI, only a video signal will be transmitted. DVI does not support audio. Mounting The B140-002-DD comes with mounting hardware that allows it to be mounted in a variety of ways. The following images show the different ways the included mounting brackets can be attached for different mounting methods.
1. Test to make sure that the entire installation works properly before pulling cables through ceilings/walls. 2. 24AWG, Solid Wire Cat5e/6 cable, such as Tripp Lite’s N202-Series, is required to achieve maximum distance and resolution. 3. The signal from input port A is transmitted to RJ45 output ports 1A and 2A. The signal from input port B is transmitted to RJ45 output ports 1B and 2B.
Page 5
B140-1A0 and B140-1A0-WP only: Connect the external power supply to the active receiver unit, and plug it into a Tripp Lite Surge Suppressor, PDU, or UPS. When receiving power, the Green RJ45 LED on the B140-1A0, and the Green Power LED on the B140-1A0-WP , will illuminate.
Page 6
1. Test to make sure that the entire installation works properly before pulling cables through ceilings/walls. 2. 24AWG, Solid Wire Cat5e/6 cable, such as Tripp Lite’s N202-Series, is required to achieve maximum distance and resolution. 3. The signal from input port A is transmitted to RJ45 output ports 1A and 2A. The signal from input port B is transmitted to RJ45 output ports 1B and 2B.
Page 7
Using Cat5e/6 cable, connect the RJ45 output port on the first repeater to the RJ45 input port on a second repeater. Connect a monitor to the DVI output port on the repeater using a Tripp Lite P561-Series DVI-D Single-Link cable.
Remote Repeater Installation Turn on the power to the DVI source. The Orange RJ45 LED’s on the B140-002-DD, B140-110, and B140-1A0, and the Orange Activity LED on the B140-1A0-WP , will illuminate. The video image should now be displayed on the connected monitors.
Page 9
Troubleshooting What resolution are you trying to reach? Tripp Lite’s DVI over Cat5 extenders are tested to support up to 1920 x 1080 @ 60Hz video resolution (See the Product Features section or the installation diagrams in this manual for details on max distance and resolution when using the repeater and the different receivers).
Page 10
Troubleshooting Check your cabling for any damages that may have occurred during installation. If a cable connector is loosened from pulling through ceilings/ walls, or the cable jacket is damaged causing the wiring to be exposed, you will not be able to achieve maximum performance. Are the transmitter, repeater, and/or receiver located in an area that exposes them to higher temperatures? If the product is overheated, it will not function properly.
Warranty & Warranty Registration 1-Year Limited Warranty TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products.
Page 12
Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide. Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.