Fluorescence Light Source (Optional); Uv Shield (Optional; Only Needed For Fluorescence) - Accu-Scope EXI-600 Manual

Inverted research microscope

Hide thumbs Also See for EXI-600:

Table of Contents

Position the turret with the "handle"

facing away from the right side of

the microscope, and slowly slide

the turret onto the track and into

the opening. Ensure that the turret

slides completely into the

microscope.

Close the cover and return the

locking lever into the horizontal

(locked) position.

5.2.11. Fluorescence light source (optional)

Align and insert the fluorescence

light source adapter dovetail into

the receiver on the back of the

microscope (requires epi-

fluorescence vertical illumination is

already installed).

Secure the light source adapter by

tightening the 2mm hex screw

using a 2mm hex screwdriver.



NOTE: A UV shield is recommended for fluorescence microscopy.

Align the holes in the UV shield

brackets with the tapped holes in

the top of the mainframe and

closest to the observation tube.

Using a 4mm hex screwdriver,

insert and tighten the provided hex

screws to secure the shield in

place.

ACCU-SCOPE

73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com

EXI-600 INVERTED MICROSCOPE SERIES

Table of Contents