Table of Contents
Advertisement
Using Fluorescence (EXI-410-FL only)
If you purchased your EXI-410 with fluorescence, your complete fluorescence system is pre-installed, aligned
and tested by our trained technicians to your specifications prior to shipment.
The complete fluorescence illumination light path includes:
•
Integrated LED fluorescence illumination modules
•
Dovetail filter slider
•
3 position fluorescence filter turret.
Each position of the filter turret features positive click stop ball-bearing positioning and printed markings
above the knurled wheel identifying the turret position in the light path.
Refer to pages 8-10 for component diagrams of the EXI-410-FL.
The EXI-410-FL is not available with alternate light sources for fluorescence.
Various filter sets are also available for installation. Selection of filter sets depends upon the available LED
fluorescence modules in your microscope. Contact your authorized ACCU-SCOPE dealer, or call us at 631-
864-1000 for a list of available and recommended filter sets.
Operating Fluorescence (EXI-410-FL only)
Epi-fluorescence illumination
As right figure shown, press the illumination selector button
to switch between epi-fluorescence illumination and
transmitted illumination modes.
The intensity of the fluorescence LED illumination will
increase when rotating direction of illumination intensity
adjustment knob as in the figure on the right, the same as
when using transmitted LED illumination.
NOTE: To minimize photobleaching of the specimen and
avoid "autofluorescence" from the transmitted LED
light module, ensure that the light shield is rotated
into its down position (as shown in the figure to the
right.
ACCU-SCOPE
®
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
EXI-410 INVERTED MICROSCOPE SERIES
Light
shield
25
Advertisement
Table of Contents
