Eyepieces; Transmitted Illumination Pillar - Accu-Scope EXI-600 Manual

Inverted research microscope

Hide thumbs Also See for EXI-600:

Table of Contents

5.2.2. Eyepieces

Remove the dust plugs from the

eyetubes.

Insert the eyepieces into the

eyetubes.

Use a 4mm hex screwdriver and

remove the 4 hex screws from the

back of the mainframe. These

screws will be used again

momentarily.

Hold the pillar above the

mainframe with the base of the

pillar directly above the mounting

position.

Align the guide pins with the slots

in the frame.

Slowly slide the pillar down into the

slots. The pillar is not yet secured,

but will not fall over.

Secure the pillar onto the frame

using the same 4 hex screws from

above.



When installed properly, the pillar

can be easily tilted backward and

forward with one hand.

ACCU-SCOPE

73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com

EXI-600 INVERTED MICROSCOPE SERIES

Eyepiece

Dust plug

Transmitted

illumination

pillar

4mm hex screws

Table of Contents