Master/Slave Setup - SHOWTEC Energetic XL User Manual

Energetic XL

Master/Slave Setup

The Energetic XL supports master/slave control mode. To connect multiple devices in a master/slave
setup, follow the steps below:
Connect the first device's DMX OUT connector to the second device's DMX IN connector with a
3-pin DMX cable.
Repeat step 1 to connect all devices as shown in Fig. 12.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device in the setup.
Set the first device on the data link as a master device. See 6.6.6. System Settings on page 27 for
more information.
Set the remaining devices as slave devices. See 6.6.5. Slave Mode on page 27 for more information.
Product code: 43169
19
Fig. 12