Table of Contents
Advertisement
Energetic XL
8.
Maintenance
Safety Instructions for Maintenance
DANGER
Electric shock caused by dangerous voltage inside
Disconnect power supply before servicing or cleaning.
WARNING
Laser radiation
Avoid exposure to beam.
This device is a class 3B laser device according to the classification in NEN-EN-IEC 60825-1:2014.
Maintenance can be carried out by instructed or skilled persons. Service shall be carried out only by
skilled persons. Contact your Highlite International dealer for more information.
Preventive Maintenance
Attention
Before each use, examine the device visually for any defects.
Make sure that:
●
All screws used for installing the device or parts of the device are tightly fastened and are not
corroded.
●
The safety devices are not damaged.
●
There are no deformations on housings, fixations and installation points.
●
The lens is not cracked or damaged.
●
The power cables are not damaged and do not show any material fatigue.
Basic Cleaning Instructions
WARNING
Laser radiation
Avoid exposure to beam
To avoid laser emission, remove the key before cleaning the device.
The external lens of the device must be cleaned periodically in order to optimize the laser output. The
cleaning schedule depends on the conditions at the site where the device is installed. When smoke or
fog machines are used at the site, the device will need more frequent cleaning. On the other hand, if the
device is installed in well-ventilated area, it will need less frequent cleaning. To establish a cleaning
schedule, examine the device at regular intervals during the first 100 hours of operation.
To clean the device, follow the steps below:
Disconnect the device from the electrical power supply.
Allow the device to cool down for at least 15 minutes.
Remove the dust collected on the external surface with dry compressed air and a soft brush.
Clean the lens with a damp cloth. Use a mild detergent solution.
Product code: 43169
34
Advertisement
Table of Contents
