Assembling The Motor - Husqvarna 536LiL Workshop Manual

Repair Instructions
7
Loosen the screw and lift off the motor while
pulling the cables out of the shaft.
See figure 3
Cleaning and inspection
Clean and check the motor. The motor must
always be replaced with a new one if cracked or
showing signs of other defects. Always use original
spare parts.
See figure 4

9.3 Assembling the motor

1
Pull the wires through the shaft. Fasten the wires
to a steel wire to make this easier.
See figure 5.
2
Fasten the motor to the shaft.
Tightening torque 6 ~ 8 Nm.
See figure 6
40 –
English
Fig 3
Fig 4
Fig 5
Fig 6