Related Manuals for Husqvarna 536LiHE3
Summary of Contents for Husqvarna 536LiHE3
- Page 1 Operator’s manual 536LiHE3 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. E E E E n n n n g g g g l l l l i i i i s s s s h h h h...
-
Page 2: Key To Symbols
KEY TO SYMBOLS Symbols on the machine: Cutting unit operating cycle, run time/ idle time Translation of the original Swedish operating instruction. Symbols on the battery WARNING! Incorrect or careless use of a hedge trimmer can turn it into a and/or on the battery dangerous tool that can cause serious charger:... -
Page 3: Table Of Contents
CONTENTS Contents Note the following before starting: KEY TO SYMBOLS Symbols on the machine: ........2 Please read the operator's manual carefully. Symbols on the battery and/or on the battery charger: ..............2 WARNING! Long-term exposure to noise Symbols in the operator’s manual: ....... 2 can result in permanent hearing impairment. -
Page 4: Introduction
Congratulations on your choice to buy a Husqvarna product! Husqvarna is based on a tradition that dates back to 1689, when the Swedish King Karl XI ordered the construction of a factory on the banks of the Husqvarna River, for production of muskets. -
Page 5: What Is What
WHAT IS WHAT? 13 14 What is what? Blade and blade guard 14 Warning indicator Transport guard 15 Rear handle Handle for tilt adjustment 16 Impact guard Tilting cutting head 17 Harness Lock for tilt adjustment 18 Battery indicator button Hand guard 19 Battery status Front handle... -
Page 6: General Safety Precautions
GENERAL SAFETY PRECAUTIONS General power tool safety • Do not overreach. Keep proper footing and balance at all times. This enables better control of warnings the power tool in unexpected situations. • Dress properly. Do not wear loose clothing or Please read the operator’s manual carefully and make jewellery. - Page 7 GENERAL SAFETY PRECAUTIONS Battery tool use and care IMPORTANT! • Recharge only with the charger specified by the Always remove the battery before any maintenance on manufacturer. A charger that is suitable for one type the machine. of battery pack may create a risk of fire when used Children should be supervised to ensure that they do with another battery pack.
-
Page 8: Personal Protective Equipment
QC charger from Husqvarna. The batteries are software HEARING PROTECTION encrypted. Wear hearing protection that provides adequate noise Use only a Husqvarna original BLi battery in your reduction. machine. Battery safety Li-ion... -
Page 9: Machine's Safety Equipment
• the battery in direct sunlight. Only use Chargers, Husqvarna QC, for charging the Husqvarna replacement batteries, BLi. Use the battery charger only when the surrounding temperature is between 5 °C and 40 °C. Use the charger in an environment which is well ventilated, dry and free from dust. -
Page 10: Control Panel
GENERAL SAFETY PRECAUTIONS arrangement means that the power trigger is WARNING! Never use a machine with automatically locked at no operation state. faulty safety equipment. The machine's safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired. - Page 11 GENERAL SAFETY PRECAUTIONS Hand guard Li-ion Li-ion The hand guard prevents hands from coming into contact with the moving blades, for example, if the operator loses grip on the front handle. • Check that the hand guard is fitted correctly. •...
-
Page 12: Battery Handling
BATTERY HANDLING Battery Connect the battery to the battery charger. The display shows the battery capacity and if there are any problems with the battery. The battery capacity is Regularly check that the battery charger and the battery displayed for 5 seconds after the machine is switched off are intact. -
Page 13: Transport And Storage
BATTERY HANDLING • Ensure the machine is cleaned and that a complete LED display Charging status service is carried out before long-term storage. The battery is 0%-25% Disposal of the battery, battery LED 1 flashes. charged. charger and machine LED 1 is lit, LED 2 The battery is 25%-50% flashes. -
Page 14: Starting And Stopping
• All covers must be correctly fitted and undamaged before you start the machine. Connect battery to the machine Use only a Husqvarna original BLi battery in your machine. Then press the power trigger up to apply full power. •... -
Page 15: Working Techniques
WORKING TECHNIQUES General working instructions that no-one comes closer than 15 metres while you are working. • Never use the machine in bad weather, for instance in IMPORTANT! fog, in rain, strong winds, intense cold, etc. This section takes up the basic safety precautions for •... -
Page 16: Basic Working Techniques
WORKING TECHNIQUES • Always use both hands to hold the machine. Hold the • Always wear heavy-duty gloves when repairing the machine at the side of your body. cutting attachment. The blades are very sharp and can easily cause cuts. •... -
Page 17: Transport Position
WORKING TECHNIQUES Changing the hedge trimmer angle Remove the battery from the machine. The cutting unit has 8 adjustment positions to make work easier. • Pull down the position adjustment handle. • Tilt the cutting unit with its handle to the desired position. -
Page 18: Maintenance
Lubricate the blade bars before long periods of storage. Only use original spare parts. Ask your Husqvarna dealer if you need more information. Regularly check that the battery charger and the battery are intact. -
Page 19: Troubleshooting Schedule
MAINTENANCE Troubleshooting schedule Control panel Troubleshooting takes place from the keypad. LED display Possible faults Possible action Green activate LED flashing. Low battery voltage. Charge the battery. The cutting attachment is jammed. Overload. Release the cutting attachment. Error LED flashes. Temperature deviation. -
Page 20: Maintenance Schedule
MAINTENANCE Maintenance schedule WARNING! Always remove the battery before any maintenance on the machine. The following is a list of the maintenance steps that must be performed on the machine. Most of the items are described in the Maintenance section. The user must only carry out the maintenance and service work described in this Operator's Manual. -
Page 21: Technical Data
- The declared vibration total value may also be used in a preliminary assessement of exposure. Use only a Husqvarna original BLi battery in your machine. Approved chargers for the specified batteries, BLi. Battery charger... -
Page 22: Ec Declaration Of Conformity
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare under sole responsibility that the hedge trimmers Husqvarna 536LiHE3 from 2016’s serial numbers and onwards (the year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the standards or or other normative documents following the provisions in the COUNCIL’S DIRECTIVES:... - Page 24 Husqvarna AB SE-561 82 Huskvarna Visiting address: Drottninggatan 2 1158348-26 ´®z+ZBr¶6;¨ ´®z+ZBr¶6;¨ 2016-10-07...