Dismantling.the.control.unit.and.battery.contact; Assembling.the.control.unit.and.battery.contact - Husqvarna LiHD50 Workshop Manual

Repair instructions LiHD60X / LiHD70X
10.7 Dismantling the control unit and
battery contact
1
Disconnect the contacts to the front handle from
the control unit.
See Chapter 8.7.
2
Loosen screws (A) on the control unit and screws
(B) on the battery contact. Loosen the contact (C)
and lift out the control unit, battery contact and
cables from the chassis.
See figure 15.
3
Loosen the contacts (D and E) in order to separate
the control unit and battery contact.
See figure 16.
Cleaning and inspection
Clean and inspect all parts. They must always
be replaced with new ones if cracked or showing
signs of other defects. Always use original spare
parts.
See figure 17.
10.8 Assembling the control unit and
battery contact
1
Connect contacts (D and E) on the battery contact
to the control unit.
NOTE!
Connect the contacts the right way round!
The contacts should be turned so that the
cables (F) and (G) are red! The cables must
hang straight down from the contacts so
they are not bent excessively.
See figure 18.
2
Place the control unit, battery contact and cables
into the chassis.
Connect the contact (C). Fasten screws (A) on the
control unit and screws (B) on the battery contact.
NOTE!
It is very important the cables are positioned
correctly in the chassis so that they are not
pinched when the machine is reassembled.
Tightening torque 3 ~ 4 Nm.
See figure 15.
3
Connect the contacts for the front handle to the
control unit.
See Chapter 8.8.
46 – English
B
A
B
C
Fig.15
Fig.16
Fig.17
F
Fig.18
A
E
D
E
D
G