Configuring The Operating Mode - National Instruments FieldPoint FP-1300 User Manual

Configuring the Operating Mode

© National Instruments Corporation
The following sections describe the functions of the DIP switch settings.
1 2 3 4 5 6 7 8
Figure 2-11. Overview of the FP-1300 DIP Switches
You can configure the FP-1300 to operate in user mode (USER) or
factory-default (DEF) mode using the USER/DEF switch.
In user mode, the FP-1300 reads its baud rate and arbitration ID from the
configuration settings that were last saved in the FP-1300 software. To
configure the module for user mode, push the USER/DEF switch to the
USER position.
Figure 2-12. USER/DEF Switch in User Mode
In factory-default mode, the FP-1300 baud rate is 500 Kbps and the
FP-1300 reads its base arbitration ID from the DIP switches on the module.
For more information about configuring base arbitration IDs using DIP
switches, refer to the Configuring the Base Arbitration ID
configure the FP-1300 to operate in factory-default mode, push the
USER/DEF switch to the DEF position.
Chapter 2 Installing and Configuring Hardware and Software
ID
Address Mode
1
0
1 2 3 4 5 6 7 8
Operating
Mode
1 2 3 4 5 6 7 8
2-11
section. To
FP-1300 User Manual