Gpib-Pc Mode Selection; Figure A-2. Gpib-Pc Mode Selection Settings - National Instruments GPIB-PCII Getting Started

Changing Hardware and Software Configuration Settings Appendix A

GPIB-PC Mode Selection

The GPIB-PCII/IIA interface board is set at the factory to function as either a
GPIB-PCII or a GPIB-PCIIA board. Using the board in its default configuration
ensures that the software configuration is consistent with the hardware. To
change the GPIB-PC mode of the board, use switch 9 in switch block U2. To
select GPIB-PCII mode, push the switch down on the side labelled PCII. To
select GPIB-PCIIA mode, push the switch down on the side labelled PCIIA.
Figure A-2 shows the GPIB-PC mode selection switch set for GPIB-PCII mode
and GPIB-PCIIA mode.
Key
= not used to select the GPIB-PC mode
U2 U2
PCIIA PCIIA
PCII PCII
a. GPIB-PCII b. GPIB-PCIIA
Mode Selected
Mode Selected

Figure A-2. GPIB-PC Mode Selection Settings

PCII/IIA and NI-488.2 MS-DOS A-2 © National Instruments Corp.