Table of Contents
Advertisement
Chapter 2
Installing and Configuring Hardware and Software
Using DIP Switches to Configure the FP-1300
If you use the FP-1300 software to configure the FP-1300, you do not need to use
Note
DIP switches to configure the base arbitration ID. Go to the
CAN Network
FP-1300 User Manual
modules, unless you mount the thermocouple modules on FP-TB-3
isothermal bases.
Refer to Figure 2-10 and complete the following steps to connect an I/O
module to a terminal base.
1.
Position the first module with its alignment slots aligned with the guide
rails on the terminal base.
I/O Module
Figure 2-10. Installing an I/O Module
2.
Firmly press the module onto the terminal base. The terminal base
latch locks the I/O module into place when the ejector button pops up
on top of the terminal base.
3.
Repeat this procedure to install additional I/O modules onto terminal
bases.
section.
To configure the base arbitration ID using the DIP switches on the FP-1300,
complete the following steps:
1.
Push the USER/DEF switch to the DEF position.
2.
Use the STD/XTD switch to configure the arbitration ID type,
standard or extended.
3.
Use the remaining DIP switches to configure the base arbitration ID.
Key
Latch
Alignment
Slot
2-10
Guide Rails
Terminal Base
Connecting the FP-1300 to the
ni.com
Advertisement
Table of Contents
