Cleaning And Maintenance - OBH Nordica Legacy 7749 Instructions Of Use

switch the blender off while doing this. If the blender is switched off with
hot liquid in it, and is then restarted, pressure may form from the bottom
due to the high speed of the motor, causing the lid to fly off and hot liquid
to splash out.
If, despite everything, the blender is turned off during the above process and
needs to be restarted, keep one hand on the lid – using a towel/pot holder or
similar – and watch out for any splashes of hot liquid. It is only hot liquid that
must not be mixed because the pressure in the jug gets too high.
IMPORTANT! We do not recommend mixing frozen berries/fruits on their own,
as they can easily freeze into a lump and then block the blades.
If you want to add other ingredients or liquid during use, you can, provided the
mixing process is stopped before the cap or entire lid is removed. Make sure
that the ingredients to be added are not too thick or too heavy for the motor to
process. If necessary, add a little liquid through the lid if the motor is struggling
or stop the mixing process and scrape the mixture toward the blade using a
rubber scrapper.
MAKE SURE THAT THE LID AND FILLER CAP ARE BOTH IN PLACE ON
THE JUG BEFORE RESTARTING THE BLENDER!
IMPORTANT! Use tepid water to clean the glass jug after mixing ice cubes, as
the jug will be chilled and hot water may create stress in the glass and cause
cracks.
Overheating
The blender is equipped with a thermostat to ensure that the appliance has
a long service life. It is activated if the motor becomes overloaded. If the
thermostat is activated, turn off the appliance and unplug it. Wait 30 minutes
before restarting the appliance. Clean the parts as instructed in "Cleaning and
maintenance".

Cleaning and maintenance

Always unplug before cleaning. Important! Always clean the blender jug after
use. This is to avoid the jug discolouring. All parts of the blender jug are
dishwasher-safe apart from the blade unit, which must be washed carefully by
hand – note that the blades are very sharp. Carefully dry all the parts before
putting them away. Do not use abrasive cleaning products. Remove any
stubborn stains by soaking and rubbing with a soft cloth and mild detergent.
Use a damp cloth when cleaning the motor section. Dry thoroughly before re-
using the appliance or putting it away.
You can also clean the blender jug by pouring around 300 ml of water into
the jug along with a few drops of washing-up liquid and then running the ice
crushing programme for 30 seconds. Then rinse the jug carefully with clean
water.
36
7749_JG_1017.indd 36 2018-08-24 11:35:27