Cleaning And Maintenance - OBH Nordica TWISTER GO Instruction Manual

Use
• Place the motor unit on a flat, stable surface and plug into a wall socket.
• Fill the blender bottle with ingredients. The maximum level is 600 ml
(see marking on bottle) and must not be exceeded. For best results, we
recommend filling the bottle with liquid ingredients first and then fresh/
frozen ingredients (cut the ingredients into pieces no larger than 2 cm). Do
not overfill the bottle.
• Screw the blade unit securely on to the open end of the blender bottle.
Then attach the bottle with the blade unit to the motor unit by aligning the
plastic spikes on the blade unit with the notches on the motor unit's bottle
connection. Mixing starts as soon as the power switch is pressed and stops
once it is released. The maximum continuous operating time is 1 minute.
This must be followed by a pause of 5 minutes.
This appliance is not suitable for mixing potatoes, cream, egg whites, dough,
etc.
NOTE! The temperature of the liquid to be added should not exceed
30°C.
The appliance must not be used with hot liquids, as the pressure at the base
will be too great.
To protect the motor, it is important not to run it for any longer than one
minute. If mixing is sluggish, release the power switch and gently shake
the bottle so that the contents are mixed around before continuing to
mix.
Turn the blender bottle so that the blade unit is upwards and remove the blade
unit. Then screw on the lid provided. The blender bottle is now ready to drink
from or take with you.

Cleaning and maintenance

Always unplug the appliance prior to cleaning and maintenance. ALL LOOSE
PARTS SHOULD BE WASHED BY HAND, ALSO THE BOTTLES. Do
not use harsh chemical cleaners or other agents with an abrasive effect.
Remove any stubborn stains by soaking and rubbing with a soft cloth and
mild detergent. Use a damp cloth when cleaning the motor unit. Dry all parts
thoroughly and reattach the blender bottle with the blade unit to the motor unit.
Snap the lid securely onto the base of the blender bottle.
Cleaning the rubber seals
When cleaning, remove the lid and blade seals in order to get rid of any
residues.
• Unscrew the blade unit from the bottle (note that the blades are very sharp).
Gently push up the blades from the blade unit from below. Remove the
26