Cleaning And Maintenance; Disposing Of The Appliance - OBH Nordica 6830 Manual

MAKE SURE THAT THE LID AND FILLER CAP ARE PLACED ON THE
BLENDER JUG BEFORE RESTARTING THE APPLIANCE!
Overheating
The blender is equipped with a thermostat to ensure that the appliance has
a long service life. It is activated if the motor becomes overloaded. If the
thermostat is activated, turn off the appliance and unplug it. Wait 30 minutes
before restarting the appliance. Clean the parts as instructed in "Cleaning and
maintenance".

Cleaning and maintenance

Always unplug before cleaning. Wash the mug, lid and blade unit in hot soapy
water or in a dishwasher after each use. Important! Always clean the jug
immediately after use. This is to avoid discoloration of the jug. Carefully dry
all the parts before putting them away. Do not use abrasive cleaning products.
Remove any stubborn stains by soaking and rubbing with a soft cloth and mild
detergent. Use a damp cloth when cleaning the motor unit. Dry thoroughly
before re-using the appliance or putting it away.
You can also clean the blender jug by pouring around 300 ml of water into
the jug along with a few drops of washing-up liquid and then running the ice
crushing programme. Then rinse the jug carefully with clean water.
Remove the blade unit from the blender jug/
take-away mug and clean it by hand or in a
dishwasher. Remember to remove the seal
located around the lock ring and around the lid
for the take-away mug and clean them. Then dry.
Note that the blades are very sharp.
If the blender jug's blade unit is difficult to
remove, use a screwdriver or similar (see
picture).
IMPORTANT!
THE MOTOR SECTION MUST NEVER BE IMMERSED IN ANY LIQUID!

Disposing of the appliance

By law, electrical and electronic equipment must be collected for the
recycling of components. Electrical and electronic equipment marked
with the waste management symbol must be disposed of at a municipal
recycling point.
40