8.3 Operation Mode Switching
■
Switching to the RUN mode
There are the following two methods.
● Press the operation button (▶) on the GM Programmer while the STOP LED is lit.
● Set the RUN/STOP switch on the GM1 Controller to RUN.
● The switch cannot be set to the RUN mode if an error that does not allow to continue operation
has occurred or if an exceptional situation has occurred.
■
Switching to the STOP mode
There are the following two methods.
● Press the stop button (■) on the GM Programmer while the RUN LED is lit.
● Set the RUN/STOP switch on the GM1 Controller to STOP.
WUME-GM1RTXOP-01
8.3 Operation Mode Switching
8-5