Quadratec QuadraTop Adventure Top S Manual page 7

FIG 26
FIG 28
Step 6: Installing the Rear Bow
Locate the rear bow as circled in FIG 22
on page 6. This bow is curved at the end
and has a flat bracket welded onto each end
as shown in FIG 23. This bow mounts to the
factory mounting point (bolt) on the rear of
the roll bar under the Roll Bar padding and
just behind the rear door surround (FIG 26).
Note that the next pictures do not show
the fabric attached to the front & rear bow.
This is for reference only. The rear bow
should be inside the hook and loop flap
during installation. Un-zip the roll bar
padding towards the rear of the vehicle just
past the rear door surround and right after
the small Velcro flap as shown in FIG 26.
Step 7: Installing the Second Center Bow
FIG 34
FIG 27
FIG 31
There will
FIG 33
just under this flap. Using a 13mm
and driver
roll bar
the rear
and replace
this install
vehicle so each bolt is
This next section is VERY important:
width of the rear roll bar legs is different on
each vehicle. We
bow bracket
When tightening these two rear bolts you
must make sure that the bow is centered on
the vehicle. Use the side roll bar as a reference
to center the rear bow. For Example: Fig 29
shows the slot exposed on the inside of
the vehicle.
and not centered. Fig 30 shows it centered in
the slot and more importantly, centered on the
roll bar.
tighten each bolt.
Re-install the roll bar padding by zipping
it back
should come
flap (FIG's 31, 32 & 33).
7
FIG 29
FIG 30
FIG 32
be a factory mounted
socket
remove this bolt from
27). Once removed,
(FIG
bow bracket over the
bolt (FIG 28).
the Repeat
on the other side of
loosely installed.
have slotted the
to compensate for
The rear bow is too far inboard
Once centered as listed above,
up.
The rear bow bracket
right out under the Velcro
FIG 35
The second center bow has a
Small metal plate welded to it.
(Fig 35)
bolt
the
slip
hole
the
The
rear
this.