Quadratec QuadraTop Adventure Top S Manual page 6

Over door bow attached to
windshield header
FIG18
Quick Release Knob
Step 5: Attach Quick Release Knobs to Over
Door Bows
Locate the two Quick release knobs and
the header/Deck Assembly shown in FIG 18.
You will be installing one Quick release
knob into each of the over door bow ends.
Line up the quick release knob in the bow end
making sure the knob portion is facing inward
and the slot on the Quick Release knob is
vertical, up and down (FIG 19).
Step 6: Installing the Rear Bow
This next step is easier and safer if you have a friend helping you. Having a person
NOTICE
on the other side of the vehicle to help lift and locate the front header assembly and
Top Deck will be very helpful.
FIG 22
Knob facing inward
towards center of top
FIG19
Using a Phillips head screw driver and the
enclosed set screws, secure the Quick
Release knob to the bow end through the pre-
drilled hole in the bow (FIG's 20 & 21).
NOTE: If you cannot get the hole started in the
Quick release knob, you may have to drill a
small pilot hole.
Tighten the screw securing the Quick
Release knob to the bow. Repeat on the other
side.
The rear bow has a flat metal plate
welded to it (FIG 23).
The rear bow ships from the factory
wrapped onto the Soft Top Deck inside a
hook and loop pocket. With the help of a
friend you will need to lay the entire top
deck assembly onto the vehicle with the
front header resting on the windshield
and the rear bow (Wrapped in the hook
and loop flap) resting on the rear of the
back roll bar legs (Fig's 24 & 25).
Proceed to page 7
6