Quadratec QuadraTop Adventure Top S Manual page 12

FIG 65
FIG 67
Step 12: Securing the Side and Rear
Windows to the Vehicle
As shown in FIG's 65 & 66, roll the vertical
plastic strip into the door surround slot securing
it to the door surround. Next, starting at the
driver's side front, attach the side belt rail
into the vehicle body by "rolling" the plastic
into the slot (FIG's 67 & 68). Once secure
move to the rear driver's side corner and "roll"
the plastic into the Jeep body corner belt rail
while pulling back towards the rear of the
vehicle as shown in FIG 69. Repeat the quarter
window and corner install on the passenger
side of the vehicle. You may have to pull the
corners around towards the front or back of the
vehicle to center the top on the vehicle and to
pull the zippers closer.
FIG 70
FIG 72
Step 13: Securing the tailgate bar & rear
window to the vehicle
Open the tailgate. Take the factory
tailgate bar and orient the "C"-Channel
with the round seal facing down. Slide
the "C" Channel onto the rear window
retainer as shown in FIG's 70 & 71.
FIG 66
FIG 68
FIG 69
FIG 71
FIG 73
Clip the rear Tail gate retaining brackets to the
body tub just outside the tailgate opening. Roll
the tailgate bar into the mounts with the outside
of the fabric facing towards the rear rear of the
Vehicle (FIG's 72 & 73).
12