Quadratec QuadraTop Adventure Top S Manual page 3

Step 2: Pillar and Rear Over Door Surround
Assembly
Locate the driver's side Rear over door assem-
bly and the driver's side Pillar assembly shown in
Fig 1.
Turn the two pieces over as shown in FIG 2
and line up the slot on the pillar assembly with
the "T" on the over door assembly.
Notice in Fig 2 that there is a secondary "T" that
will be lined up when you slide the long "T" into the
long slot. Slide the two pieces together lining up
both "T's" to secure the top over door assembly
with the Pillar assembly. See FIGs 3 & 4.
Locate the small screw packet in the hardware kit
found in the door surround box. Using a Phillips
head screw driver, install the screw into the screw
hole on the two assembled parts securing them
permanently together. See FIGS 5, 6 & 7.
Repeat the above assembly on the Passenger
side Rear over door and pillar assemblies.
3