Advertisement
Quick Links
QuadraTop
This Replacement Top kit is designed to fit on your 4 Dr Jeep® Wrangler when
the original soft top or hard top has been completely removed. Before begin-
NOTICE
ning your installation of this product, you will need to remove your existing soft
top fabric, hardware or Hard top.
Loss of vehicle control involves risk of death or serious injury, particularly to
parts of your body not restrained within vehicle. This product is intended for
weather protection only and should not be relied upon to contain occupants
in the event of an accident or to protect from either ground contact or falling
objects. To reduce risk of accident or injury:
•
ALWAYS WEAR SEATBELTS
WARNING
•
Always keep head, arms & body parts within vehicle.
•
Fully secure or stow the soft top before driving according to instructions.
Never try to latch or fold soft top while driving. Do not use if damaged or
worn.
•
Read and follow all instructions & warnings accompanying this product, in
your vehicle owner's manual and Off Road Driving Supplement.
RISK OF EYE INJURY. Safety glasses should be worn at all times while install-
CAUTION
ing or maintaining this product.
PART LIST:
TOP DECK/HEADER AND REAR BOWS ASSEMBLY QTY 1
DRIVER SIDE QUARTER WINDOW
PASSENGER SIDE QUARTER WINDOW
REAR WINDOW
CENTER BOW ASSEMBLY
DRIVER SIDE DOOR SURROUND
PASSENGER SIDE DOOR SURROUND
DOOR SURROUND RUBBER
DOOR SURRUND SCREWS
DOOR SURROND KNOBS
TAILGATE BAR
TAILGATE BAR CORNER MOUNTS
CORNER MOUNTS SHORT KNOBS
REAR BOW SCREWS AND NUTS
REAR BRACKET SCREWS & NUTS
REAR MAIN BRACKET SCREWS AND NUTS
4MM ALLEN WRENCH
REAR MAIN BRACKET SCREW M8
5MM ALLEN WRENCH
Complete Soft Top
®
for 2018-Current
4 Door Jeep
Wrangler JLU
®
Item
11113.2435
#
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 8
QTY 1
QTY 8
QTY 2
QTY 4
QTY 8
QTY 4
QTY 2
QTY 2
QTY 1
QTY 4
QTY 1
REQUIRED TOOLS:
SAFETY GLASSES
SOCKET WRENCH
10MM SOCKET & DRIVER
PHILLIPS HEAD SCREW DRIVER
Advertisement
Related Manuals for Quadratec QuadraTop 11113.2435
Summary of Contents for Quadratec QuadraTop 11113.2435
- Page 1 QuadraTop Complete Soft Top ® for 2018-Current 4 Door Jeep Wrangler JLU ® Item 11113.2435 This Replacement Top kit is designed to fit on your 4 Dr Jeep® Wrangler when the original soft top or hard top has been completely removed. Before begin- NOTICE ning your installation of this product, you will need to remove your existing soft top fabric, hardware or Hard top.
- Page 2 You CAN be moderately HURT and also may suffer property damage if you don’t follow instructions. Careful attention is required to this instruction or operation but does general- ly not relate to personal injury. Damage to your Quadratec® product or other NOTICE property may result if you don’t follow instructions.
- Page 3 Step 2: Rear Over-Door Surround Remove these screws and set aside. Assembly Place the rubber seal on the driver’s Locate the driver’s side rear over door side pillar assembly (Fig 3A) Line up assembly, the driver’s side Pillar assem- the Driver side pillar assembly and the bly, The Rubber seal and the 4mm Allen driver side rear over door assembly as head wrench (Fig 2).
- Page 4 Step 4: Secure Front & Rear Note: if you have difficult lining up Door Surrounds to the Roll Bar the top of the knobs with the upper Locate the two sets of screw knobs bracket hole, you can remove the and the driver’s side front and rear installed top brackets covering the door surrounds.
- Page 5 Step 5: Installing the Center Bows The quick release knob is spring load- #1 & #2 ed so you should here a “click” when it is secure in the bracket (Fig 16). once Locate the center bow #1 (Fig 14). the bow is installed, tighten the bow Each Bow has been labeled to make mount bracket on the door surround.
- Page 6 Step 7: Installing the Deck and FIG 19 Front Windshield Header Continued The bow arms will install to the front bow mount brackets located on the top of the door surrounds. With the help of a friend, lift each of the bow legs over the bow mount bracket (Fig 19).
- Page 7 Step 9: Installing the Rear Main Make sure the pin secures the Bracket to the Vehicle rear leg as shown in fig 30 & 31. Repeat this procedure on the passen- On the rear sport bar, pull off the ger side. plastic cover that comes with the Jeep.
- Page 8 Step 11: Installing the Top Deck FIG 36 Once the rear bow is installed (Step 10), SLOWLY fold the front header down resting the windshield header on the windshield (fig 36). The first time you fold this header down it will be very tight.
- Page 9 Step 12: Installing the Side quarter FIG 42 window Locate the drivers rear quarter window. Line up and slide the rear quarter win- dow into the “C” Channel sewn on the Top Deck as shown in FIG’s 42 & 43. Repeat on the passenger side Step 13: Attaching the Corner Mounts and Tailgate Bar...
- Page 10 Step 15: Installing the Rear FIG 50 Windows Locate the rear window and line up and slide the rear window into the “C” Channel located at the top of the rear portion of the top deck and slide it across (FIGs 50 & 51). Once both quarter windows and the upper portion of the rear window are FIG 51...
- Page 11 Step 16: Securing the Side and Rear FIG 56 Windows to the Vehicle As shown in fig’s 56 & 57, roll the ver- tical plastic strip into the door surround slot securing it to the door surround. Next, starting at the driver’s side front, attach the side belt rail into the vehicle body by “rolling”...
- Page 12 Step 17: Securing the tailgate bar & Once the Tailgate bar in secure, lower rear window to the vehicle zippers on both sides of the rear cur- tain and move to the rear driver’s side Take the tailgate bar and orient the corner mounts and “roll”...
- Page 13 Using Your Fastback Soft Top-Continued FIG 71 Option #3 & #4 Fully Open Front and Rear Passen- ger “Sun Roof”: These options open both the front cab and rear cab portions of the top. This option requires you to remove the front header arms and the two bows from the bow mount brackets.
- Page 14 Using Your Fastback Soft Top- FIG 75 Center Center Front Bow Bow #1 Bow #2 Continued Folding your soft top all the way back and securing To fold back and secure your top, re- Front Leg move the rear and quarter windows from your soft top.
- Page 15 (do not use “polished” out using the window polish listed the brush on the window glass!). You on page 15 (Available at Quadratec.com). can also use special soft top clean- ers Water/Fabric: In the event of seeping available on our website and shown on page 15.
- Page 16 The exclusive remedy provided hereun- provided exclusively by Quadratec, Inc. 1028 der shall, upon Quadratec inspection and at Quadratec’s option, be either repair or Saunders Lane, West Chester, PA 19380. replacement of product or parts (new or This Limited Warranty is the only warranty refurbished) covered under this Limited made in connection with purchase.