Advertisement
Quick Links
Quadratec
QRC
®
JK Rear Bumper
Installation Manual for 2007 - Current Wrangler (JK)
#
12057.0220
QRC Rear Bumper: 12057.0220
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS AND PROCEDURE NOTICES BEFORE
ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT
ALL TIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.
TORQUE AND RECHECK FASTENERS AFTER 250 MILES AND
FREQUENTLY THEREAFTER. INSPECT BUMPER BEFORE USE.
DO NOT USE IF DAMAGED.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING
PERMITTED BUMPER TYPES AND HEIGHTS.
BUMPERS ARE HEAVY AND WE STRONGLY SUGGEST THE
ASSISTANCE OF AN ABLE-BODIED ASSISTANT DURING LIFTING
AND INSTALLATION OF YOUR BUMPER.
®
The Trusted Source
Advertisement
Related Manuals for Quadratec QRC JK
Summary of Contents for Quadratec QRC JK
- Page 1 Quadratec ® JK Rear Bumper Installation Manual for 2007 - Current Wrangler (JK) 12057.0220 QRC Rear Bumper: 12057.0220 TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
- Page 2 Careful attention is required to this instruction or operation but does ® generally not relate to personal injury. Damage to your Quadratec product or other property may result if you don’t follow instructions. Before You Begin Installation: Congratulations on your purchase of looking like new.
-
Page 3: Required Tools
QRC JK Rear Bumper Parts & Tools: KIT CONTENTS LIST: KIT CONTENTS LIST (continued): A.) QRC Rear Bumper (1) G.) M10 Flat Washers (4) B.) M12 Bolts (4) H.) Nut Plate Brackets (2) C.) M12 Lock Washers (4) D.) M12 Flat Washers (4) REQUIRED TOOLS: E.) M10 Bolts (4) - Page 4 QRC JK Rear Bumper Installation: Figure 1 Figure 2 Put on safety glasses. Open the tailgate Remove the four M10 bolts holding the and swing it & the spare tire out of the rear bumper support brackets to the way. Remove the four M10 bolts (2 per frame using a 16mm socket.
- Page 5 QRC JK Rear Bumper Installation: Figure 5 Figure 6 Align the threaded holes in the nut person, and with the tailgate partially plates with the holes in the frame rail. open lift the bumper and gently rest it (FIG5) Then, with assistance of another on the frame rails of the vehicle.
- Page 6 QRC JK Rear Bumper Installation: Figure 9 Figure 10 Adjust the bumper to the desired M10 Bolts to 37 ft lbs. (FIG10) Fully alignment. (FIG9) Then, install the M10 tighten the larger M12 bolts at this time bolts, lock washer and flat washer in the with a 18mm socket.
- Page 7 QRC JK Rear Bumper Care: Your Bumper has been designed and On all bumpers there is a chance of manufactured to provide years of use. some surface rust showing over time However, like any product, general due to metal particles being embedded maintenance is required to keep it in the paint.
- Page 8 Quadratec to obtain a RGA number only to Quadratec branded accessories first sold (610-701-3336). All labor, removal, shipping in the United States, Quadratec warrants to the and installation costs are customer’s initial retail purchaser only that your responsibility.