Quadratec QuadraTop Adventure Top S Manual
Soft top with flip back sunroof for 2007-2018 4 door jeep wrangler jku
Hide thumbs
Also See for QuadraTop Adventure Top S:
- Installation manual (21 pages) ,
- Manual (15 pages) ,
- Manual (13 pages)
Advertisement
Quick Links
QuadraTop
With Flip Back Sunroof
Loss of vehicle control involves risk of death or serious injury, particularly to parts
WARNING
of your body not restrained within vehicle. This product is intended for weather
protection only and should not be relied upon to contain occupants in the event of
an accident or to protect from either ground contact or falling objects. To reduce
risk of accident or injury:
•
ALWAYS WEAR SEATBELTS
•
Always keep head, arms & body parts within vehicle.
•
Fully secure or stow the soft top before driving according to instructions. Ne-
ver try to latch or fold soft top while driving. Do not use if damaged or worn.
•
Read and follow all instructions & warnings accompanying this product, in
your vehicle owner's manual and Off Road Driving Supplement.
RISK OF EYE INJURY. Safety glasses should be worn at all times while installing or
CAUTION
maintaining this product.
PART LIST:
TOP DECK/HEADER ASSEMBLY
DRIVER SIDE QUARTER WINDOW
PASSENGER SIDE QUARTER WINDOW
REAR WINDOW
REAR BOW ASSSEMBLY
CENTER BOW ASSEMBLY
DRIVER'S SIDE DOOR SURROUND
PASSENGER SIDE DOOR SURROUND
DOOR SURROUND KNOBS
RE AR D-RING STRAP ASSEMBLIES
OVER DOOR BOW QUICK RELEASE
Adventure Top
®
For 2007-2018
4 Door Jeep® Wrangler JKU
#
Item
11113.1535
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 4
QTY 2
QTY 2
S
REQUIRED TOOLS:
SAFETY GLASSES
PHILLIPS SCREW DRIVER
FLAT HEAD SCREW DRIVER
SOCKET WRENCH
13mm SOCKET
Advertisement
Related Manuals for Quadratec QuadraTop Adventure Top S
Summary of Contents for Quadratec QuadraTop Adventure Top S
- Page 1 QuadraTop Adventure Top ® With Flip Back Sunroof For 2007-2018 4 Door Jeep® Wrangler JKU Item 11113.1535 Loss of vehicle control involves risk of death or serious injury, particularly to parts WARNING of your body not restrained within vehicle. This product is intended for weather protection only and should not be relied upon to contain occupants in the event of an accident or to protect from either ground contact or falling objects.
- Page 2 Careful attention is required to this instruction or operation but does generally not NOTICE relate to personal injury. Damage to your Quadratec® product or other property may result if you don’t follow instructions. Before you begin Installation: Thank you again for your purchase and let’s...
- Page 3 Notice in Fig 2 that there is a secondary “T” that Step 2: Pillar and Rear Over Door Surround will be lined up when you slide the long “T” into the Assembly long slot. Slide the two pieces together lining up both “T’s”...
- Page 4 FIG 10 FIG 12 FIG 11 Step 3: Install Rear Door Surrounds to Jeep Locate the assembled Driver’s side rear door surround (Fig 8). On the bottom of the vertical pillar portion of the assembled door surround is a pin that will be inserted into the body tub as shown in FIG9.
- Page 5 Step 4: Secure Front & Rear Door Surrounds Repeat this procedure on the back of the to Roll Bar rear door surround. Finally, with the short Locate the two sets of screw knobs in each Door knob secu-re the “sandwiched” front & rear surround box.
- Page 6 Over door bow attached to Knob facing inward windshield header towards center of top FIG19 FIG18 Quick Release Knob Step 5: Attach Quick Release Knobs to Over Using a Phillips head screw driver and the enclosed set screws, secure the Quick Door Bows Release knob to the bow end through the pre- Locate the two Quick release knobs and...
- Page 7 FIG 27 FIG 26 FIG 28 FIG 29 FIG 30 FIG 32 FIG 31 There will factory mounted bolt FIG 33 just under this flap. Using a 13mm socket and driver remove this bolt from 27). Once removed, roll bar (FIG slip the rear...
- Page 8 FIG 36 FIG 37 hole over the door surround hole (FIG 36). Step 7: Installing the Second Center Bow Make sure the bow is rear of the Door Surround Locate the second center bow as circled in FIG34. This bow has a small flat bracket Knob.
- Page 9 FIG 43 FIG 44 FIG 45 Step 9: Installing the Top Deck and Front Windshield Header Assembly With the first bow installed to the vehicle and the front windshield header folded back (FIG 43), locate the Quick Release knobs on the ends of the over door bows and slip the knob into the hole in the first bow mount (FIG 44) by pulling the knob out and then releasing.
- Page 10 FIG 51 FIG 52 Step Installing FIG 54 FIG 53 Deck (Continued): Thread tensioner through the flap/tube sewn into the t h e t e n s i o n e r top deck and attach spring assembly that hanging out 51).
- Page 11 FIG 59 FIG 60 FIG 61 FIG 62 FIG 63 FIG 64 Go inside to the back seat of the vehicle and Step 11: Installing the Side and Rear Windows (Continued) Once both quarter windows and the locate the second center bow hook and loop flap sewn into the top deck.
- Page 12 FIG 65 FIG 66 FIG 67 FIG 68 Step 12: Securing the Side and Rear Windows to the Vehicle As shown in FIG’s 65 & 66, roll the vertical FIG 69 plastic strip into the door surround slot securing it to the door surround. Next, starting at the driver’s side front, attach the side belt rail into the vehicle body by “rolling”...
- Page 13 FIG 74 FIG 75 FIG 76 FIG 77 FIG 78 Step 14: Securing the Hook and Loop Fastners Once the Tailgate bar in secure, lower zippers on both sides of the rear curtain and then secure the rear corner flaps as shown in FIG 74. Work your way around the out-side of the vehicle and secure all Hook and loop sealing up the zippers above the windows and down the rear...
- Page 14 “polished” out using the window polish listed on page 15 (Available Zippers: Keeping the zipper cleaned and at Quadratec.com). lubricated with a silicone lubricant (see Page 15) will help prevent damage and Water/Fabric: In the event of seeping keep the zippers in a smooth working con- through the seams, 3M Scotchgard®...
- Page 15 Quadratec Exclusive Products Also Available: Q-Performance Stealth Winch Quadratec’s all NEW Q-Performance Stealth Winches are waterproof and submersible with an IP67 rating. The wireless remote control adds convenience, safety and long range winching when outside the cab. The die cast finned aluminum solenoid housings dissipate...
- Page 16 Quadratec, Inc. 1028 der shall, upon Quadratec inspection and Saunders Lane, West Chester, PA 19380. at Quadratec’s option, be either repair or replacement of product or parts (new or This Limited Warranty is the only warranty refurbished) covered under this Limited made in connection with purchase.