Advertisement
Quick Links
Quadratec
QRC
®
Rear Bumper
Installation Manual for '18 - Current Wrangler JL Vehicles
#
12057.0241
Rear Bumper
Bumper
Installation Hardware
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS AND PROCEDURE NOTI ES BEFORE
ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT
ALL TIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.
TORQUE AND RECHECK FASTENERS AFTER 250 MILES AND
FREQUENTLY THEREAFTER. INSPECT BUMPER, WINCH AND
MOUNT BEFORE USE. DO NOT USE IF DAMAGED.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING
PERMITTED BUMPER TYPES AND HEIGHTS.
Advertisement
Related Manuals for Quadratec QRC
Summary of Contents for Quadratec QRC
- Page 1 Quadratec ® Rear Bumper Installation Manual for ’18 - Current Wrangler JL Vehicles 12057.0241 Rear Bumper Bumper Installation Hardware TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTI ES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
- Page 2 Careful attention is required to this instruction or operation but does ® generally not relate to personal injury. Damage to your Quadratec product or other property may result if you don’t follow instructions. Before You Begin Installation: Congratulations on your purchase of for important care &...
-
Page 3: Required Tools
Quadratec QRC Rear Bumper Parts & Hardware: BUMPER PARTS LIST: 1) Rear Bumper QTY 1 2) License Plate Mount QTY 1 Rear Bumper Shown HARDWARE LIST: Packet 12057.0293 A.) M14 Nut Plate QTY 1 B.) M14-1.50 x 40 Hex Head Bolt QTY 2 C.) M14 Lock Washer... - Page 4 JL Rear Bumper Installation Prep: FIG1 FIG2 Put on safety glasses. Start by removing Remove the 8 bolts holding the support the factory splash guard. Remove the 6 brackets on, 4 on either side, using a screws holding the inner shields on, 3 on 16mm socket.
- Page 5 JL Rear Bumper Installation Prep: FIG7 FIG8 Remove the bumpers harness by gently Bumper harness without backup sensors prying on all tie wrap fasteners and dis- shown. (FIG 8) This bumper is not connecting the license plate light. (FIG 7) designed to work with backup sensors.
- Page 6 JL Rear Bumper Installation: FIG11 FIG12 With the assistance of another person, lock washers using a 21mm socket (FIG and with the tailgate partially open lift 12). Snug the bottom bolts first, but do the bumper and gently rest it on the not tighten and then insert the original frame rails.
- Page 7 JL Rear Bumper Installation: Rear Bumper Shown installed with the Quadratec License Plate Light (sold separately) Bumper Care: Your Bumper has been designed and these chips. This will prevent any manufactured to provide years of use. corrosion from forming. On all bumpers...
- Page 8 Quadratec to obtain a RGA number only to Quadratec branded accessories first sold (610-701-3336). All labor, removal, shipping in the United States, Quadratec warrants to the and installation costs are customer’s initial retail purchaser only that your responsibility.