Quadratec QuadraTop Adventure Top S Manual page 4

FIG 11
Step 3: Install Rear Door Surrounds to Jeep
Locate the assembled Driver's side rear door
surround (Fig 8). On the bottom of the vertical
pillar portion of the assembled door surround is a
pin that will be inserted into the body tub as shown
in FIG9.
On the body tub you may have a rubber seal
that is called out in FIG 10. This seal will
remain on the body tub. Insert the door surround
pin into the body tub as shown in FIG 11
(with the seal under the door surround). After
inserting the pin, locate the
the door surround "C"
push onto roll bar (Figs 12 & 13).
The "C" should fit in the cutout of the roll bar
pad. Line up the threads in the "C" with the top
hole in the roll bar.
Repeat this procedure on the passenger side.
FIG 10
FIG 12
upper portion
attachment and
4