Advertisement
Quick Links
QuadraTop® Adventure Soft Top
Installation Manual: for 2004-2006 LJ Wrangler #11113.1135
PARTS & REQUIRED TOOLS
REQUIRED TOOLS:
Safety Glasses
Phillips Head Screwdriver
Large Soft Towel
Power Drill
1/8" Drill Bit
PART LIST:
A)Windshield Header with Top Decks
B)Passenger Side Door Surround Kit
C)Driver Side Door Surround Kit
D)Tailgate Bar with Clips
E)Center Bow
F) Driver/Passenger Over Door Bows
G) Drivers Side Quarter Window
H) Passenger Side Quarter Window
I) Rear Window
Throughout this instruction
sheet pictures of a TJ
Wrangler are used. Install on
LJ Wrangler is the same.
QTY 1
QTY 1
QTY 1
QTY 1
QTY 1
QTY 2
QTY 1
QTY 1
QTY 1
Advertisement
Related Manuals for Quadratec QuadraTop 11113.1135
Summary of Contents for Quadratec QuadraTop 11113.1135
- Page 1 QuadraTop® Adventure Soft Top Installation Manual: for 2004-2006 LJ Wrangler #11113.1135 Throughout this instruction sheet pictures of a TJ Wrangler are used. Install on LJ Wrangler is the same. PARTS & REQUIRED TOOLS PART LIST: REQUIRED TOOLS: A)Windshield Header with Top Decks QTY 1 Safety Glasses B)Passenger Side Door Surround Kit...
- Page 2 BEFORE YOU BEGIN INSTALLATION: Congratulations on your purchase of the Quadratec® QuadraTop for your Jeep® Wrangler. This custom fit soft accessory has been designed for protection, long life, and great looks. When unpacking, check to make sure all parts are included and not damaged due to shipping.
- Page 3 Step 1 FIG 4 FIG 1 FIG 2 FIG 3 FIG 5 FIG 8 FIG 6 FIG 7 Windshield Header/Over Door Bow Installation Put on safety glasses. After removing all existing Soft top or hard top hardware/fabric/top, locate the Header/Top Deck assembly shown in Fig1 and lay the assembly on either the box lid or a soft towel Locate the two over door bows shown in Fig2.
- Page 4 FIG 4 FIG 12 FIG 11 FIG 13 Locate the “C” clamps on the upper horizontal over door section and line them up with the holes in the horizontal tubes of the roll bar. Press the “C” clamps onto the horizontal tubes and the front portion of the door surrounds forward into the rubber gasket on the windshield (FIGs 11&...
- Page 5 Step 4 FIG 21 FIG 22 FIG 23 Installing the Center Bow to the Door Surrounds Locate the Center Bow assembly with the pre-installed quick release knuckles on the ends. With the top folded back as shown in FIG20, locate the bottom rear-most bracket hole (FIG21) and slip the rear bow through the webbing strap loop located on corner of the top deck (Fig 21A).
- Page 6 Step 6 FIG 34 FIG 35 FIG 36 FIG 37 FIG 38 FIG 39 Install the Rear Tailgate Bar Brackets If the vehicle has previously had a tailgate bar bracket (Soft Top Vehicles): Place the Tailgate Bar Bracket on the outside of the tailgate opening lining up each hole (from previous Tailgate brack- ets) with the existing holes already drilled in the tailgate (FIGs 35 &...
- Page 7 Step 7B FIG 47 FIG 44 FIG 45 FIG 46 FIG 48 Installing the Rear Window to the Top Deck Locate the rear window and line up and slide the rear window into the “C” Channel located at the top of the rear portion of the top deck (FIGs 44, 45 &...
- Page 8 Step 8 FIG 50 FIG 49 FIG 52 FIG 51 FIG 56 FIG 55 FIG 53 FIG 54 Installing the Top to the Jeep® Body Starting at the driver’s side front, right behind the front seat, attach the front vertical belt rail into the door surround slot by “rolling the plastic into the slot (FIGs 49 &...
- Page 9 Step 10 FIG 61 FIG 62 FIG 64 FIG 63 Install the Tailgate Bar and Rear Window to the Body of the Jeep® Slide the”C” shaped channel onto the tube sewn into the rear window with the round seal down. See FIG 61 for correct alignment.
- Page 10 Using your Adventure Top FIG 69 Your Adventure Top has been designed with a fold-back “sunroof” feature that gives you the ultimate in open air experience! FIG 70 FIG 71 FIG 72 FIG 73 FIG B FIG C FIG A Folding Back the Front Section of your Top Your SkyMaster Fastback top has been designed with a fold back “sunroof”...
- Page 11 Care and Maintenance Product: Your Quadratec is made of the finest materials available but to keep it looking new and for the maximum possible wear, it will need periodic cleaning and basic maintenance. The main threat to your soft top is pollutants, dirt and grime.
- Page 12 3 years from date of initial retail sale. Quadratec reserves the rights to: (a.) require invoice or other proof your accessory is within the terms of thisLimited Warranty as a condition of warranty service and, (b.) make future revisions to this product and Limited Warranty without prior notice or obligation to upgrade your product.