Quadratec QuadraTop Adventure Top S Manual page 5

Step 4: Secure Front & Rear Door Surrounds
to Roll Bar
Locate the two sets of screw knobs in each Door
surround box. There should be (2) sets of three
knobs with two the same length and one shorter
length. The shorter knob attaches to the center
hole on the door surrounds and the (2) longer
knobs go on the front and rear holes.
Line up the door surround "C" attachment holes
with the vertical holes in the roll bar.
Slip the front knob through the hole in the front
door surround (FIG14 & 15). Tighten the knob
securing the front door surround.
Repeat this procedure on the back of the
rear door surround. Finally, with the short
knob secu-re the "sandwiched" front & rear
door surrounds with the short knob and
tighten all three knobs (FIGs 16 & 17).
All knobs on both sides of the vehicle should
be secured to the roll bar.
NOTE: You will be removing the knob shown in
FIG 16 and the rear knob to install the first
and second bow assembly but by securing it
at this step it ensures the door surrounds
are secure.
This completes the installation of the door
surrounds to your vehicle.
5