Table of Contents
Advertisement
G600EC/G600C
Enamel/Steel Panel installation (Steel Panels - Part # 776-907, Enamel Panels - Part # 776-908)
PART # 776-907, 776-908
For Black Enamel Panels:
• Black enamel panels must be inspected for scratches and dimples
prior to installation. All claims are to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
* All hand and fingerprints MUST be cleaned off with a soft cloth.
Use an ammonia-based cleaner (ie. glass cleaner) to remove any
fingerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
Note: Do not install the firebed grate, media, vermiculite, embers,
and logs until the enamel/steel panels are installed.
1. Remove screen and glass door, if installed.
2. Loosen two screws in locations shown below. Slide upper baffle
towards the back wall and then remove from unit.
3. Loosen 2 screws on pilot assembly in locations shown below.
Slide pilot shield towards the back of the unit and remove from
unit.
4. Install back panel carefully. Tilt panel forward from the top and rest
the bottom of the panel on the firebox floor. Tip top back until it also
rests on the firebox back wall.
920-296
ENAMEL/STEEL PANEL INSTALLATION
5. Loosen screws and remove brick clips.
1
3
2
Item
Part #
Description
1
N/A
Inside Top of Firebox
2
N/A
Panel
3
761-049 Brick Clip
4
904-519 Screw
6. Install the right side panel—the angled face should be located facing
the bottom rear of the fireplace when installing.
7. With panel in position, secure it with the brick clip removed in Step
5 and tighten the screw.
8. Repeat Steps 5-7 on the left side.
9. Slide the bottom panel carefully underneath the burner and
push to the back until it contacts the back panel.
10. Reinstall the upper baffle.
11. Reinstall the pilot shield removed in step 3.
1
4
08.04.20
G600C Gas Fireplace | 67
Grandview
®
installation
Advertisement
Table of Contents
