Table of Contents
Advertisement
installation
Conversion from NG to LP for G600C Using SIT 885 PROFLAME Gas Valve
LP CONVERSION
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LP Conversion Kit
Conversion Kit #776-977 contains:
Qty.
Part #
Description
1
904-977
Burner Orifice #55
1
904-529
5/32" Allen Key
1
918-590
Decal "Converted
to LPG"
1
908-528
Red "LP" label
1
910-037
L P Injector (Pilot
Orifice)
1
920-326
Instruction Sheet
Installation of LP
Conversion Kit:
1. Shut off the gas and electrical supply.
2. Remove the safety screen.
3. Remove the glass door.
4. Remove the logs, glass, and any other
media.
5. Remove the two log supports (4 screws)
and the grate assembly (2 screws).
Diagram 1: Remove 6 screws.
6. Remove three screws, then remove the
burner assembly.
Diagram 2: Slide burner assembly to the
right, then remove.
62 | Grandview
G600C Gas Fireplace
®
920-326
IF IN DOUBT DO NOT DO THIS CONVERSION !
7. Remove the pilot retainer clip below the
pilot cap.
Pilot retainer clip
8. Pull off the pilot cap to expose the pilot
orifice.
9. Unscrew the pilot orifice with the Allen
key. Replace it with the LPG pilot orifice
provided in the kit.
10. Re-install pilot cap and pilot retainer clip.
11. Remove burner orifice with a 3/8"
12. Reinstall new LPG burner orifice
13. Turn control knob to the "OFF" position.
14) Remove the black
Fig.2
1
G600C
wrench. Use another wrench to hold the
elbow behind the orifice. Discard orifice.
(stamped #55) and tighten.
Locate the "Hi/Lo" knob on the gas valve.
See diagram below.
protection cap from
the Hi-Lo knob
(Fig.1).
Fig. 1
15) Insert a 5/32" or 4mm
Allen wrench into the
hexagonal key-way
of the screw (Fig. 2).
Rotate it counter-
clockwise until it is
free and extract it.
Installer Notice:
These instructions must
remain with the appliance.
09.21.20
Advertisement
Table of Contents
