Table of Contents
Advertisement
installation
Log Set Installation
G600EC/G600C/G600C-1
Read the instructions below carefully and refer to the diagrams.
If logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The G600EC/G600C/G600C-1 log sets, #776-930 for Grandview Oak,
#776-932 for Grandview Birch, contain the following pieces:
1
Rear Log
2
Middle Left Log
3
Middle Right Log
4
Center Left Cross Log
5
Front Bottom 'Y' Log
6
Left Rear Log
7
Right Cross Log
8
Middle Front
9
Left Log Piece
10
Right Log Piece
11
Left Front Log Piece
12
Right Front Log Piece
Must also purchase (#776-938),
Log Grate and Ember Package,
separately. The kit contains:
NOTE: Panels (brick, steel, or enamel) must be installed
prior to installing the log set.
1. Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position when
installing.
Diagram 1-Log ID
68 | Grandview
G600C Gas Fireplace
®
920-294
Log Grate
3/4" Ginger glass
Vermiculite
Black/White Embers
Log Support Plates
Page 1 of 4
LOG SET INSTALLATION
2. Install the log grate—secure with 2 screws in locations shown below.
Diagram 2-Log Grate Install
3. Install the supplied crystals over the ember lights underneath the
burner as shown. Place vermiculite and embers on top of the glass.
Do not place any media on the burner.
Diagram 3-Install Glass
Diagram 4-Install Vermiculite + Lava
Warning: Glass crystals must be placed at least 1" away from the
front edge of the unit.
09.16.20
Advertisement
Table of Contents
