Table of Contents
Advertisement
installation
Cool Wall Installation-Cool Wall Conversion
1. Remove safety screen from unit as per manual.
2. Remove the three screws from the top of the unit, holding the top
cover in place.
3. Remove the top cover piece and secure it to the rear right
side of the unit with one screw as shown.
4. Remove the strip of insulation.
5. Remove the three screws from the inner cover piece in the
locations shown.
26 | Grandview
G600C Gas Fireplace
®
6. Remove the inner cover piece and secure it to the left rear side of the
unit with one screw as shown.
7. Loosen the two outermost screws which are accessed through the holes
in the locations show below. NOTE: Do not remove these two screws;
loosen them.
8. Reach underneath the top of the unit and locate the lower sliding portion
of the cool wall assembly. Push this piece toward the back of the unit as
far as it will go to open the cool wall air channel.
9. Tighten the two outer screws that were loosened to secure the sliding
piece in place.
Advertisement
Table of Contents
